Quantum G6 / G7 Diagnostic tool
5. Fault Codes
5.9. Error Code 33
The heater shows FAULT 33 error code. (Series G6)
This means the Charge Controller is getting too hot
Send Engineer with replacement Charge Controller part 03/82034/0
Skip Table of contents
Skip Quantum Diagnostic Tools G6/G7
Table of contents
- 1. Introduction
- 2. Quantum Series Type and Documents
- 3. Installation
- 3.1. Can you install Quantum RF (Series G6) on a Single Supply?
- 3.2. What electricity tariffs can Quantum RF use?
- 3.3. Can the Quantum Series G6 be connected to the internet or "Dimplex Control" App?
- 3.4. Can I use Quantum with OVO Energy's special tariff?
- 3.5. Can you install Quantum RF Series G6 on a 3 pin plug?
- 3.6. Can I lock the heater to prevent tampering & how to unlock?
- 3.7. Enable or Disable Open Window Detection
- 3.8. What is Setback & how do you Enable or Disable it?
- 3.9. What is Adaptive Start & how do you Enable or Disable it?
- 3.10. Changing between Celsius and Fahrenheit
- 3.11. How many bricks are needed?
- 3.12. Commissioning Checklist
- 4. Help Videos
- 5. Fault Codes
- 5.1. Error Code 00 (Safe Mode )
- 5.2. Error code 20
- 5.3. Error Code 21
- 5.4. Error Code 22
- 5.5. Error Code 23
- 5.6. Error Code 24
- 5.7. Error Code 30
- 5.8. Error Code 32
- 5.9. Error Code 33
- 5.10. Error Code 34
- 5.11. Error Code 40
- 5.12. Error Code 41
- 5.13. Error Code 50
- 5.14. Error Code 51
- 5.15. Error Code 52
- 5.16. Error Code 53
- 5.17. Error Code 54
- 5.18. Error Code 55
- 5.19. Error Code 60
- 5.20. Error Code 61
- 6. Report Screens
- 7. Trouble Groups
- 8. Power Issues
- 9. Operation
- 10. Temperature
- 11. Noise
- 12. Smells
- 13. Discolouration
- 14. Water