Quantum G6 / G7 Diagnostic tool
3. Installation
3.10. Changing between Celsius and Fahrenheit
Changing between Celsius and Fahrenheit
Skip Table of contents
Skip Quantum Diagnostic Tools G6/G7
Table of contents
- 1. Introduction
- 2. Quantum Series Type and Documents
- 3. Installation
- 3.1. Can you install Quantum RF (Series G6) on a Single Supply?
- 3.2. What electricity tariffs can Quantum RF use?
- 3.3. Can the Quantum Series G6 be connected to the internet or "Dimplex Control" App?
- 3.4. Can I use Quantum with OVO Energy's special tariff?
- 3.5. Can you install Quantum RF Series G6 on a 3 pin plug?
- 3.6. Can I lock the heater to prevent tampering & how to unlock?
- 3.7. Enable or Disable Open Window Detection
- 3.8. What is Setback & how do you Enable or Disable it?
- 3.9. What is Adaptive Start & how do you Enable or Disable it?
- 3.10. Changing between Celsius and Fahrenheit
- 3.11. How many bricks are needed?
- 3.12. Commissioning Checklist
- 4. Help Videos
- 5. Fault Codes
- 5.1. Error Code 00 (Safe Mode )
- 5.2. Error code 20
- 5.3. Error Code 21
- 5.4. Error Code 22
- 5.5. Error Code 23
- 5.6. Error Code 24
- 5.7. Error Code 30
- 5.8. Error Code 32
- 5.9. Error Code 33
- 5.10. Error Code 34
- 5.11. Error Code 40
- 5.12. Error Code 41
- 5.13. Error Code 50
- 5.14. Error Code 51
- 5.15. Error Code 52
- 5.16. Error Code 53
- 5.17. Error Code 54
- 5.18. Error Code 55
- 5.19. Error Code 60
- 5.20. Error Code 61
- 6. Report Screens
- 7. Trouble Groups
- 8. Power Issues
- 9. Operation
- 10. Temperature
- 11. Noise
- 12. Smells
- 13. Discolouration
- 14. Water